Huffy Fitness Equipment 89224 User Manual

Customer Service  
N53 W24700 South Corporate Circle  
Sussex, WI 53089  
U.S.A.  
A Huffy Company  
Model 89224  
SAFETY INSTRUCTIONS  
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY  
RESULT IN SERIOUS INJURY,  
PROPERTY DAMAGE AND WILL VOID WARRANTY.  
This unit is intended for display purposes only and  
should not be used for play.  
BASKETBALL  
BALL  
CENTER  
BASKET  
To ensure safety, do not attempt to assemble this system without  
following the instructions carefully. Check entire box and inside all  
packing material for parts. Before beginning assembly, read the  
instructions and identify parts in this document. Proper and  
complete assembly, use and supervision is essential for proper  
operation and to reduce the risk of accident or injury. A high  
probability of serious injury exists if this system is not installed,  
maintained, and operated properly.  
CENTER  
During assembly, if using a ladder use extreme caution. Two  
people are recommended for this operation.  
If technical assistance is required, contact Huffy Sports’ Sample  
and Display Technician.  
Serious injury could occur if teeth/face come in contact with  
backboard, net or rim.  
Display recommended for 3” (7.6 cm) or 3-1/2” (9 cm) Round or 4”  
(10 cm) Square poles only.  
All instructions and warnings MUST accompany any display item  
that is sold.  
REQUIRED TOOLS AND  
MATERIALS:  
Wrenches: (Two each) 7/16”, 1/2”, 9/16”,  
and 3/4” or Pliers  
Most injuries are caused by misuse and/or not following  
instructions.  
Use caution when installing this unit.  
Step Ladder, 8 ft. (2.4 m)  
IMPORTANT!  
To ensure prompt and correct handling of any problems, or to answer any questions, please contact the Sample  
and Display Technician at 1-800-558-5234.  
P/N 211678A  
06/03  
1
 
48” Fan Backboard  
44” Fan  
(Remains in  
center location)  
44” Fan  
Backboard  
CURRENT  
INSTALLATION  
DIAGRAM  
EXACTA HEIGHT POLE  
ASSEMBLY:  
REMOVE & DISCARD  
OR IT MAY BE LOCATED  
IN A DIFFERENT  
CORNER.  
44” Steel Framed Acrylic  
FRONT  
The side with pegboard on  
the top and bottom.  
P/N 211678A  
06/03  
3
 
Install pole mounting hardware and pole for each  
assembly.  
WARNING  
4
TWO PEOPLE ARE  
NECESSARY TO MOUNT THE  
ELEVATOR ASSEMBLY TO  
THE POLE. ONE PERSON  
SHOULD NOT ATTEMPT TO  
DO THIS ALONE.  
3-1/2” Rnd. Pole X 30” Pole  
Upper Support  
Railing  
3-1/2” Rnd. Pole  
TOP  
VIEW  
3-1/2” Rnd. Pole  
10  
8
3-1/2” Rnd. Pole  
9
FRONT  
P/N 211678A  
06/03  
4
 
INSTALLATION DIAGRAM  
WARNING  
Assemble display products per diagram below.  
TWO PERSON MINIMUM  
REQUIRED FOR THIS  
PROCEDURE. NOT  
FOLLOWING  
RECOMMENDATION MAY  
RESULT IN BODILY INJURY.  
48” Fan  
Backboard  
44” Fan  
44” Fan  
FRONT  
44” Rectangle  
Steel Framed  
Acrylic  
48” Rectangle Steel  
Framed Acrylic  
P/N 211678A  
06/03  
5
 
Refer To Combo For  
Goal Assembly  
Instructions  
Mount extension arm and  
rim to backboard and  
finger tighten as shown.  
NOTE: For spring  
loaded rim assembly,  
refer to instructions  
included with rim  
hardware.  
1.  
1
2.  
Secure hardware to extension  
arm as shown and tighten  
completely. Install pole cap (2).  
2
4
7
5
5
3
6
P/N 211678A  
06/03  
6
 

Graco Baby Accessories PD150904A User Manual
Graco Car Seat 8491 User Manual
HANNspree Flat Panel Television F621 15U1 000 User Manual
HANNspree Flat Panel Television WT04 12A1 User Manual
Hans Grohe Indoor Furnishings 1801001 User Manual
Hans Grohe Plumbing Product 04193000 User Manual
Hoshizaki Refrigerator PTR1SSB FGFG User Manual
Hotpoint Washer Dryer AQGL129PI User Manual
Huawei Modem E219 User Manual
IMC Networks Switch Giga AcessEtherLinx II User Manual